Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
POWER SUPPLY
Power adapter included.
Power IN
100-240V~
Power OUT
16,8V DC 2000mA
DMX CONNECTION
Connection between lights and DMX must use the shied cable of diameter more than 0.5mm. Please use the
attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket and
cable as below (note the plug/socket's 3 pin number and position).
DMX-OUTPUT
XLR mounting-sockets (rear view)
2
When using standard DMX512 control signal, the last device's output interface must be connected to a DMX plug.
This plug is putting a 120 ohm resistance between "canon" plug's 2 pin and 3 pin. Showing as below pic. Sticking
this plug into the last device's signal output interface, it will avoid the interference during the process of signal
transmission.
RIGGING
Attention! The installation must be carried out by qualified service personal only. Improper installation can re-
sult in serious injuries and /or damage to property. Overhead rigging required extensive experience! Working
load limits should be respected, Certified installation materials should be used, the installed device should be
inspected regularly for safety.
1 ∙ Shield
2 ∙ Shield (-)
1
3 ∙ Shield (+)
3
DMX-INTPUT
XLR mounting-plugs (rear view)
2
1
3
P.19
PIN3
PIN2
Publicidad
