Descargar Imprimir esta página

Hendi 860083 Manual Del Usuario página 7

Sopera eléctrica
Ocultar thumbs Ver también para 860083:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
Main parts of the product
(Fig.1 on page 4)
1. Lid
2. Soup container
3. Decorative cover
4. Water tank
5. Housing
6. Temperature control knob
7. Indicator light
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all accesso-
ries. In case of incomplete or damaged delivery, please contact
the supplier immediately. In this case, do not use the device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
1. Fill water to water tank to MAX level. Do not below MIN level.
2. Fill soup to soup container below the MAX level.
3. Connect the appliance to power supply.
4. Adjust temperature control knob.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Clean and descale the boiler base at regular intervals (see
chapter "Descaling")
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
Descaling
This appliance should be cleaned and descaled frequently. To
keep this appliance in optimum condition and to ensure its op-
eration, it is crucial that you descale the appliance on a regular
basis. Depending on the hardness of the water and the frequen-
cy of use, you need to repeat the following procedure regularly.
To descale use a descaling agent that is suitable for the appli-
ance. You can also use pure lemon juice, citric acid or cleaning
vinegar as a descaling agent. To ensure the proper mixture,
read the instructions supplied with the agent. For pure lem-
on juice or cleaning vinegar the general mixture applies of 1/3
cleaning vinegar or lemon juice to 2/3 water.
1. Pour the solution in the boiler to maximum the"MAX" level.
2. Heat the solution by maximum temperature for 15mins.
3. Wait to allow the solution to loosen the build-up.
4. Rub lightly and gently with a brush with soft bristles.
5. Drain off the dirty water.
6. Repeat steps 1~5 until build-up has been removed.
7. Use a dry cloth to wipe the solution away.
8. When you drain off dirty water, leave the tap open and rinse
the boiler with clean water till taste and smell are completely
gone.
9. Now you can use the appliance again.
NOTE! Warranty is void if failure to descale regularly leads to
reduced functioning or failure of the appliance.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problem
Possible cause
Appliance does not
No power at the
work
socket
The plug is not
plugged (correctly)
into the power
point
GB
Possible solution
Check the fuse
Check the plug
7

Publicidad

loading