Publicidad
Idiomas disponibles
Idiomas disponibles
Read these instructions
and this manual
in
its entirety
before
you attempt
to assemble
or operate
your new lawn mower.
IMPORTANT:
This lawn mower is shipped
WITHOUT
OIL OR GASOLINE
in the
engine.
Your new lawn mower
has been assem-
bled at the factory
with the exception
of
those
parts left unassembled
for shipping
purposes.
All parts such as nuts, wash-
ers, bolts, etc., necessary
to complete
the
assembly
have been placed
in the parts
bag.
To ensure
safe and proper
opera-
tion of your lawn mower,
all parts and
hardware
you assemble
must be tightened
securely.
Use the correct
tools as neces-
sary to ensure
proper
tightness.
TO REMOVE
MOWER
FROM
CARTON
1. Remove loose parts included with
mower.
2. Cut down two end corners of carton
and lay end panel down flat.
3. Remove all packing materials except
padding between upper and lower
handle and padding holding operator
presence control bar to upper handle.
4. Roll mower out of carton and check
carton thoroughly for additional loose
parts.
HOW
TO SET
UP YOUR
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle
carefully
so
as not to pinch or damage
control
cables.
1.
Raise lower handle
section
to operat-
ing position
and align hole in handle
with one of three height
positioning
holes.
2.
Insert
handle
bolt through
handle
and
bracket
and secure
with knob.
3.
Repeat
for opposite
side of handle.
4.
Remove
protective
padding,
raise up-
per handle
section
into place on lower
handle
and tighten
both handle
knobs.
5.
Remove
any packing
material
from
around
control
bar.
Your lawn mower
handle
can be adjusted
for your mowing
comfort.
Refer to "AD-
JUST
HANDLE"
in the Service
and Adjust-
ments
section
of this manual.
O
MOWING
POSITION
control bar
Upper
UP
handle
Handle
knob
Lower handle
Handle
bracket
'Bolt
Knob
Publicidad
