Mighty Seven DOS-501 Manual De Instrucciones página 14

WARNING:
goggles or safety glasses with side shields
during power tool operations, or when
blowing dust. If operation is dusty, also
wear a dust mask.
WARNING:
brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which
may result in serious personal injury.
MAINTENANCE
From time to time, remove the dust bag from
the sander and clean the dust bag with a dry
brush.
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety goggles when cleaning tools with
compressed air.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use a clean cloth to remove dirt, dust, oil,
grease, etc.
BEFORE EACH USE
1. Inspect the sander, the on/off switch
and the accessories for damage.
2. Check for damaged, missing, or worn
parts.
3. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
4. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
5. Detach the battery from the sander
before cleaning or performing any
maintenance. Using compressed air
may be the most effective cleaning
14
method.
MAINTENANCE
Always wear safety
Do not at any time let
6. Always wear safety goggles when
cleaning tools using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated
with a sufficient amount of high grade
lubricant for the life of the unit under normal
conditions. Therefore, no further lubrication
is required.
REPLACE THE BASE PAD
FIG. 7
1. Remove four screws on the base pad,
and then detach the cap from the base
pad.
2. Align four holes on the cap with four
holes on the base pad, and then insert
the cap into the new base pad.
3. Place the new base pad on the cap base
with four holes on the base pad aligned
with four holes on the cap base.
4. Retighten four screws on the base pad.
NOTICE: Sanding pad can be a
replacement for the pad of this random
orbital sander.
WARNING:
from the sander before replacing the base
pad.
Screw
Base Pad
Cap
Cap Base
Detach the battery