Munchkin Push to Close Gate Manual Del Usuario página 6

How To Install
5a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at each
pencil mark. Insert a drywall anchor into each hole.
Use a screwdriver or drill to insert the screws through
the lower hinge wall bracket into the drywall anchors.
Medium Drywall
screw anchor
5b. For Drywall with Stud:
Drill a 5/64"(2mm) pilot hole into the stud at each
pencil mark (no anchor needed).
Use a screwdriver or drill to insert the screws through
the lower hinge wall bracket into the stud.
Medium
screw
10
STEP 4: INSTALL LOWER CATCH (WALL BRACKET)
1. Place template "B" against
5a. Drywall
7/32"
5.5mm
2. Determine whether there is a stud behind the drywall
5a. Plasterboard
3a. For Drywall Without Stud / Plasterboard:
7/32"
5.5mm
5b. Stud
3b. For Drywall with Stud:
5/64"
2.0mm
the wall with tape, flush to
the floor with tape, flush to
Temp. B
the floor. Mark the screw
(Catch Side)
holes in the cut-out piece
with a pencil to create
indentation, then remove
the template.
where you will install the lower catch wall bracket.
Proceed to either 3a or 3b.
Drill a 7/32"(5.5mm) hole into the drywall at the
center mark. Insert a drywall anchor. Then, use a
screwdriver or drill to insert the screws through the
lower catch wall bracket into the drywall anchor.
Drywall Medium
anchor screw
Drill a 5/64"(2mm) pilot hole into the stud at each
pencil mark (no anchor needed). Then, use a
screwdriver or drill to insert the screws through the
lower catch wall bracket into the stud.
Medium
screw
How To Install
3a. Drywall
7/32"
5.5mm
3a. Plasterboard
7/32"
5.5mm
3b. Stud
5/64"
2.0mm
11