VEVOR TDGC2-500VA Manual De Instrucciones página 5

The average ambient temperature is +40 degrees Celsius to -15 degrees
Celsius.
The pressure regulator should not be installed more than 1000m above
sea level, 90% relative humidity of the air.
The power supply voltage wave type is a sine wave.
It should be used in an environment free of explosive and corrosive
substances such as gas, smoke, chemical dirt, and dust discharge.
The site of use should be free of severe vibration and water
immersion.
Two or more devices are not allowed to be used in parallel.
When using under special conditions that do not meet the above
conditions, please contact our customer service.
Note:
This product has a built-in temperature protection switch, when the
internal temperature of the machine exceeds about 100 degrees Celsius,
the machine will automatically turn off the voltage output, and the voltage
output will be automatically restored when the internal temperature of the
machine is lower than about 85 degrees Celsius.
When the machine automatically shuts off the output during use, please
check whether the current used has exceeded the rated current of the
machine, otherwise the machine will always be in the cycle of automatic
shutdown and automatic start.
Most of the machines are equipped with overload protectors, when used
improperly, the overload protector will automatically jump out and turn off
the voltage output, at this time, please check whether the load is
short-circuited, seriously over-rated current, and after confirming that it is
correct, you can press the reset button of the overload protector by hand,
and the equipment will restart working.
In use, the device suddenly stops working, and the reset overload
protector has waited for the temperature of the device to drop, and the
device still cannot work normally, at this time, please take out the current
SERVICE CONDITIONS
- 4 -