Publicidad
Idiomas disponibles
Idiomas disponibles
Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1
2
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on,
the display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on
the Delay timer. Shows the Set temperature while
setting the temperature in Cool or Eco modes.
3. Temp and Delay Increase + /Decrease - Pads
can be set in Cool and Eco mode.
4. Mode Pad
Eco mode.
5. Fan Speed Pad
In Cool or Eco
Auto, High, Med or Low on the unit.
In Fan Only
High, Med, or Low on the unit.
6. Timer Pad
(set by remote control only)
Timer ON – When the air conditioner is off, it can
be set to automatically come in 1 to 24 hours.
How to set:
Press the Timer
the +/– pads to set the temperature, then press the
Timer
in 1 hour intervals and press the Timer pad for a
third time to set the timer. Once the timer is set
pressing the Timer pad will cancel the timer.
Timer OFF – When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Timer
+/– pads to set the Timer in 1 hour intervals and
press the Timer pad again to set the Timer. Once
the Timer is set pressing the Timer pad will cancel
the Timer.
49-5000870 Rev. 0
3
4
Mode
Cool
F F
Fan
Eco
Speed
Auto
ow
Med
High
5
Fan Only, Cool, or
+/– pads to set the timer
8
7
Filter
Sleep
WiFi
Solid light indicates WiFi
9
connected
Blinking light indicates
connecting
See Appliance Communication
section in this manual
7.
Sleep Pad
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and
FAN only settings.
Press the SLEEP mode pad and its light will
illuminate. The fan indicator will stay at the same
setting but the air conditioner will automatically
change the FAN speed to low in either COOL or
FAN only mode.
In FAN only mode, the fan will stay in the LOW
speed setting for 10 hours. After 10 hours, the air
conditioner will exit SLEEP mode.
In COOL mode, the fan will stay in the LOW speed
setting for 10 hours from the time the SLEEP mode
pad was pressed. The air conditioner will also raise
the set point 2°F in 30 minutes and 2°F more in
another 40 minutes where it will remain for the next
7 hours. After 10 hours, the air conditioner will exit
SLEEP mode.
While the unit is in SLEEP mode, pressing any pad
(except WIFI pad), the unit will exit SLEEP mode.
8.
Filter Reset Pad
This feature automatically notifies you that the air
filter must be cleaned. The indicator light will come
on after 500 hours of operation. Clean the air filter
(refer to page 7), place it back in the front panel,
and press the Filter Reset pad. The light will go off.
9. WiFi Connect Pad
Enables connection of the air conditioner to the
home WiFi. Download App for details at:
www.GEAppliances.com/connect.
10. Display Pad
Pressing the Display pad on the remote will switch
all lights on the LED display on/off.
Remote Control
(set by air conditioner controls only)
5
Publicidad
