Publicidad
Idiomas disponibles
Idiomas disponibles
- Do not let the power cord touch any hot surfaces.
- Do not use the device without water. This can damage the device.
- Do not use the device for cleaning electrical equipment and
installations.
- Do not touch any hot surfaces. Before installing or removing
accessories, turn the device off and wait for cooling down.
DEVICE DESCRIPTION
1.
Housing
2.
Steam plate
3.
On / off switch
4.
Operating status indicator light
5.
Steam ejection on/off button with
lock
Fabric brush (8) - allows better steam penetration, ideal for thick fabrics such as coats; allows
to pick up threads, hair, lint or hair from delicate materials such as velour, velvet or wool
quickly.
BEFORE FIRST USE
1. Take the device out of the box and remove all protecting cardboard and foil.
2. Unwind and straighten the cord before use.
CAUTION! A smoke may come out of the device during the first use. This phenomenon stops
after a short while.
PREPARATION FOR USE
FILLING THE WATER TANK
1. Make sure the device is not connected to the mains.
2. Remove the water tank (6).
3. Remove the water filler cap (6a).
4. Fill the tank with water to the maximum level.
ATTENTION! To prevent scale formation, always use fresh demineralized or distilled water. Do
not use chemically descaled water or any other liquids.
5. Close the water filler hole (6a).
6. Put the water tank back into the device.
INSTALLATION OF ACCESSORIES
1. In order to put on the overlay, disconnect the device from the power source and wait until it cools
down completely.
2. Then, holding the device firmly with one hand, put on the brush with the other so that the pro-
trusions in the attachment fit into the recesses in the working part of the device; a "click" will be
heard if lock will be placed correctly. To remove the cap, hold the device firmly and pull the handle
at the bottom of the cap.
6.
Water tank with a capacity of 260 mL
6a. Water filler cap
7.
2.5 m rotating mains cable
8.
Pad for thicker fabrics and pet hair
removal
EN
21
Publicidad
