ELBE RNP-R14L Manual De Instrucciones página 9

Elbe cleaning recommendation
Today, modern sanitary and kitchen fittings as well as showers are made of very different materials in order to meet the demands
of the market in terms of design and functionality. To avoid damage and complaints, certain criteria must be observed both during
use and subsequent cleaning.
When caring for the taps and showers, the following points should always be observed:
• Only cleaning agents expressly intended for this area of application may be used.
• Cleaners containing hydrochloric acid, formic acid, chlorine bleaching lye or acetic acid must not be used as they can cause
considerable damage.
• Cleaners containing phosphoric acid should only be used to a limited extent.
• Cleaning agents should generally not be mixed.
• Abrasive cleaning tools and equipment such as unsuitable scrubbing brushes, padded sponges and microfibre cloths should
also not be used.
• It is essential to follow the cleaning agent manufacturer's instructions for use.
• Cleaning must be carried out in accordance with the specified amount of cleaning agent, the exposure time, the specific objects
and the requirements. objects and the requirements.
• The formation of limescale must be prevented by regular cleaning.
• When spray cleaning, do not spray the cleaning solution onto the fittings under any circumstances, but onto the cleaning cloth
and use it to clean the fittings. use the cleaning cloth for cleaning, as the spray mist will penetrate into the openings and
crevices of the fittings and cause damage. and crevices of the fittings and cause damage there.
• After cleaning, rinse sufficiently with clear water to completely remove any residual adhesion of cleaning agents. residues of
cleaning agents.
• The use of steam cleaners is not permitted, as the high temperatures can damage the products. can damage the products.
Important notes
Residues of personal care products such as liquid soaps, shampoos and shower gels can also cause damage. Here, too,
the rule is: rinse off residues carefully with water after use. Likewise, no cleaning agents or chemicals should be stored under
the products, e.g. in a vanity unit, as the vapours can otherwise damage the products. If the surfaces are already damaged,
the damage will be further advanced by the cleaning agents.
Components with damaged surfaces must be replaced, otherwise there is a risk of injury. Damage caused by improper handling
is not covered by our warranty.
Safety instructions
! This product is only approved for bathing, sanitary and body cleaning purposes.
! Gloves must be worn during assembly to avoid crushing and cutting injuries.
! The holder is only intended for gripping the shower head and must not support any other objects!
! Children and adults with physical, mental and/or other impairments must not be left unattended when using the product.
! Persons under the influence of alcohol or drugs must not use the shower system.
! Contact of sensitive body parts (e.g. eyes) with the shower head jet must be avoided. A sufficient distance must be maintained
between the shower head and the person's head.
! The product is not a hand shower and must not be used as such. A separate hand shower must be purchased and attached for
this purpose.
! Excessive pressure differences between hot and cold water pipes must be compensated.
Notes on installation
• The product must be inspected for transport damage before installation. Transport damage or surface damage will not be
recognised after installation.
• Pipelines and valves must be installed, flushed and tested according to the current standards.
• Please observe the installation regulations applicable in your country.
• The installation dimensions given in these installation instructions are ideal for people with a body height of approx. 180 cm.
The dimensions can be changed as required. In this case, you must note that if the installation height is changed, the minimum
height of the shower to the floor also changes and the change in connection dimensions must be taken into account.
• When the product is installed by a qualified professional, make sure that the surfaces are level in all areas
(no protruding joints or tiles) and that the wall structure is suitable for the product installation and has no defects.
• The shower may only be connected to a mixer tap or shower thermostat.
9