Installing The Software - Panasonic EYFR02 Manual De Instrucciones

Installing the software

● Before installing the software, quit all other open applications.
1. Double-click "Panasonic Device Programmer.zip."
2. Double-click "exe file", then follow the instructions on the screen to install
the software.
● Restart the computer once the installation is complete.
Disclaimer
Be sure to read before use.
Limitations:
The Device Programmer software is designed to be used to configure EYFR0
(Assembly Qualifier) settings.
Caution:
The following precautionary information applies to use of this software:
Use of the software signifies your acceptance of the following terms of use.
Terms of Use:
• Panasonic makes no guarantee concerning the operation of this software.
• Panasonic is not liable for any direct, indirect, secondary, consequential, or
special damage arising from the use or operation of this software, either by
extension or effect.
• It is prohibited to reproduce or distribute this software.
Configuring settings with the software
1. Connect the Assembly Qualifier to the computer.
• Use an RS-232C straight cable.
Using a serial RS-3C port to
connect the Assembly Qualifier
RS-3C straight cable
2. Turn on the Assembly Qualifier.
3. Launch the Device Programmer application.
4. Click the "Read Settings" button.
• The software will load the Assembly Qualifier's current settings.
Using a USB port to connect the
Assembly Qualifier
RS-3C
straight cable
- 9 -
USB serial conversion
adapter