Cleaning And Maintenance; Drain Residual Water - HAEGER IM-10I.003B Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Notes:
Make sure the water level in the water reservoir is not over the Ice collecting tray.
Only use water at room temperature.
3. Replace the ice cube container and close the lid.
4. Press ON/OFF to start the ice cube production. The process takes between 9 and 13 minutes.
5. Keep the lid closed.
Note: For the first three cycles, the ice may be small and irregular in size.
6. If the indicator light ADD WATER is turned on, the ice cube production is automatically halted. Take
out the ice cube container and refill with potable water the water tank. Press ON/OFF button to
restart the Ice maker.
7. If indicator ICE FULL is turned on, please take out the ice cubes with the scoop. Press ON/OFF
button to restart the Ice maker.
Notes:
If no water is pumped up to the water tray over two cycles but the water in water tank is enough,
then please move the unit ahead a little, then remove the silicon stopper, and let several drops
water runs out.
When the ice collecting tray is full please remove the ice immediately. Do not allow the ice
collecting tray to overfill.

Cleaning and Maintenance

Always unplug the appliance from the power socket before performing any cleaning or maintenance
operations.
-
Clean the appliance using a damp cloth then dry with a dry cloth.
- Do not use harsh or abrasive cleaning agents.
- Do not use petrol, alcohol or solvents to clean the appliance.
- Do not submerge the appliance in water.
- Remove the ice cube container and clean it with a mild detergent under running warm water.
-
Clean casing and interior with a damp cloth.
-
Use a diluted solution of vinegar and water.

Drain residual water

Drain the residual water if the appliance is not in use for a longer period.
To drain the residual water, remove the silicon stopper.
After the residual water has been drained, put again the silicon stopper.
Note:
– For hygienic reasons exchange the water in the tank after 24 hours.
– To avoid fungi and bacteria leave the lid open after use.
4
Instructions for use

Publicidad

Tabla de contenido
loading

Tabla de contenido