Publicidad
Idiomas disponibles
Idiomas disponibles
Multipurpose Butane Soldering Tool
WARNINGS:
1 . Do not fill gas or store near open flame, heater or
combustible metarials.
2 . Use only high quality Butane Gas.
3 . Butane Gas is highly flammable, please handle
with care.
4 . Do not drop, puncture or incinerate.
5 . Do not store or operate in a place where the
temperature is higher than 50° C or 122° F.
6 . Keep out of reach of children.
7 . Cool down before putting protective cap on or storing.
GAS FILLING AND REFILLING:
1 . Ensure the switch is turned to "OFF" position
before filling.
2 . Reverse the unit; insert the gas container's nozzle
vertically into the filling valve.
3 . When gas escapes from the filling valve remove
the nozzle from the filling valve.
IGNITION:
1 . Move the flow control knob to the low position.
2 . Move the switch upward and to the right.
3 . Press down the ignition button to light up the
open flame.
4. When the unit is working as a soldering tool, 3 sec.
after lighting the torch, please move the shut off lever
to the left and release it, then the open flame will
be shut off and you will find the soldering head
becomes red.
SHUTTING OFF:
Move the switch to the left and downward, the switch
will return to "OFF" position.
TROUBLE SHOOTING:
TROUBLE
Does not ignite.
Torch flame has no proper power.
Tip does not heat up.
FLAME LENGTH OR TEMPERATURE ADJUSTMENT:
After ignition, turn the flow control knob right to
increase the flame length of the torch or the tempera-
ture of the soldering tip or hot air, or to the left to
decrease the flame length or the temperature.
OPERATING TIPS:
1. After filling or refilling with gas, wait for appr.
2 minutes so that the gas in the cylinder can stabilize.
2. Soldering tips must be tin-plated before using them
for the first time. A thin layer of solder should be
applied to the tip when it has been heated.
3. Soldering should NOT be carried out on "live"
circuits, as this soldering unit does not possess any
special electrical insulation.
4. Keep your soldering sponge moist.
HOW TO FIT OR REPLACE DIFFERENT
ACCESSORIES:
Note: Always allow the unit to cool before removing or
replacing the tip.
1. Replace soldering tip.
With 7 mm. wrench on the soldering tip or hot blow
head and 8 mm. wrench on the soldering head, you
can tighten the tip or hot blow head or unscrew them.
2. When you unscrew the nut, you can turn loose the
guard and soldering head, then this unit becomes
an open flame torch.
PROBABLE CAUSE
1. Empty gas.
2. Gas pressure too high or
too low.
1. Insufficient gas power.
1. Insufficient gas power.
2. Catalyst is damaged.
3
211106
CORRECTION
1. Refill Butane Gas.
2. Slide flow control knob to a lower
or higher position.
1. Refill Butane Gas.
1. Refill Butane Gas.
2. Replace with a new part.
Vedpak 136_Version 3_12.2015
Publicidad
