SmartGyro Sunset Manual De Usuario página 39

Turning counterclockwise by hand, insert the pedal marked with an "L" into the
crank on the left side of the bicycle. It is recommended to pay attention since
the threads of the left connecting rod are inverted with respect to those of the
right connecting rod. Be sure not to "cross thread" as this could strip the
connecting rod threads. Do not force if it does not turn easily.
Once the pedal is inserted into the crank, securely fasten the bolt to the crank
with a 15mm spanner or adjustable spanner. WARNING: IF THE PEDALS ARE NOT
PROPERLY INSTALLED AND FASTENED, THEY MAY BE LOOSE, DAMAGE THE BICYCLE
AND CAUSING POSSIBLE SERIOUS INJURY OR DEATH TO THE RIDER.
6. Mounting the saddle
Adjust the correct height of the seat as shown in the figure based on the height
of the cyclist, paying attention to the insertion depth of the seat post, which
must not be less than that indicated by the safety line.
English
5. Mounting the pedals
Insert the pedal marked "R" into the crank clockwise
on the right side of the bike. Be sure not to "cross
thread" as this could strip the connecting rod
threads. Do not force if it does not turn easily.
Unscrew the pedal and start over. Once the pedal is
inserted into the crank, securely fasten the bolt to the
crank with a 15mm spanner or adjustable spanner.
Sunset- Manual
1 37