Pebaro PROFIline Instrucciones De Uso página 8

EN
INSTALLING METAL OVERARM
1. Turn the main unit upside down and insert the metal
overarm into the bottom of the main unit as shown
below.
2. Use the overarm fixation knob from the accessories to
fix the metal overarm in position.
INSTALLING HEATER WIRE
1. Slide the spool carrier into the open end of the metal
overarm with the correct orientation as shown below.
2. Unwind heater wire from the wire spool for approx.
10" (25cm) and fit heater wire in between the two metal
washers.
3. Pull the heater wire down and thread into the heater wire
hole for ~2" (5cm)
4. Turn the clamping knob to secure the heater wire.
5. Slide the spool carrier to the cutting angle you desire
(e.g., 90 degrees), and tighten the fixation knob.
6. Hint: you may push the open end of the overarm slightly
downwards when threading the heater wire in order
to ensure the wire is taut with some tension when the
overarm is released.
7. Adjust if necessary.
READ ALL INSTRUCTIONS BEFORE USE. SAVE THESE INSTRUCTIONS.
Important Safety Precautions
1. CAUTION - The tool reaches high temperature! May cause burn.
2. CAUTION - Always ensure the unit is in off position, before adjusting or touching the heater wire.
3. Do not touch the heater wire or hot tip when in use.
4. Misuse may cause burns, electric shock and injuries.
5. Do not immerse tool in water or other liquid! Danger of electric shock!
6. Always use the tool on a heatproof and uncluttered table.
7. Do not use the device near curtains or other combustible materials.
8. Do not leave the unit unattended when in use. Keep out of reach of children.
9. A fter finished using the tool, switch OFF the unit and let the unit cool naturally before storing away.
10. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
11. This equipment is not intended to be used by persons (including children) with limited physical, sensory or mental capabilities
or lack of experience and / or knowledge, unless they are supervised or received by a person responsible for their safety
instructions from her on how to use the device.
12. Children should be supervised to ensure that they do not play with the tool.
13. Cleaning and user maintenance shall not be made by children without supervision.
14. For domestic use only. Use only for the intended purposes.
8
2
1
3
4
1
2