Publicidad
4. SYSTEM CONNECTION
ANTENNA
60 cm
CAMERA
5. INSTALLATION OF THE SYSTEM
Set #1 - Micro-Camera
• Once the optimal site of your camera of retreat found (ideally on the level of the night light of
plate or in high position), bore a central hole of Ø16 mm to make to pass the electric cables,
then two holes of Ø6 mm to fix the clamp.
• Connect the connector gun of the camera with that of the extension of 2.5 m.
• Connect the black wire to a mass (-), the red wire with a source +12V after-contact and the
wire yellow with a source +12V reversing light.
Set #2 - Camera on clamp
• Once the optimal site of your camera of retreat found (ideally in high position), then bore a
hole of Ø13 mm to make pass the electric cables.
• Connect the connector JACK of the camera with that of the extension of 1.5 m.
• Connect the black wire to a mass (-), the red wire with one
source +12V reversing light.
CAMERA
POWER
250 cm
Ground (-)
+12V reverse light
+12V after-contact
Ground (-)
150 cm
CAMERA
POWER
12
68 cm
High position
Low position (night light of plate)
CAMERA
Publicidad
