Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING PUMP KIT
4
INSTALL NEW DRAIN TUBING
Install the new white drain tubing in the accessories
to the drain pump and clamp with snap ring
included in the kit. Please ensure that the side with
arrow faces up during installation.
Snap Ring
White Drain Tubing
5
INSTALL THE DRAIN PUMP
Insert the red connector of the drain pump into the
red connector you will see on a wire inside of the
ice machine.
Red Connectors
Slide the drain pump into the ice machine so the
base slides under the tab on the base of the ice
machine floor. The front of the pump with the hose
attached will face the front of the ice machine.
31-1000617 Rev. 3
Installation Instructions
(Cont.)
Tab
5
INSTALL THE DRAIN PUMP
(Cont.)
Using the hardware from
the kit, attach the pump
to the ice maker floor
using a wrench.
6
CONNECT DRAIN PUMP TO ICE
MACHINE
For pump kit without small plastic snap ring (item
10 in Pump kit content list).
Save the big plastic snap ring and the small metal
clamp from original tube assembly.
tube of the PVC pipe as shown in the picture
below. Push the pipe up to connect both tubes
to the fittings from the ice machine which you
disconnected earlier. Snap and secure the big
snap ring back and tighten on the connection of
the main drain tube. Slide up and secure the small
metal clamp up at the connection.
For pump kit coming with small plastic snap ring
(item 10 in Pump kit content list),
assembly and pick up the small plastic snap ring
from pump package.
to the fittings from the ice machine which you
disconnected earlier. Snap and secure the 2 plastic
snap rings, one large and one small, onto the
connections and tighten on the drain tube.
3
Publicidad
