Installation
Right door
24
English
Untitled-3 24
1. Disconnect the wire connectors (x2)
on the right door. The position of the
connectors differs with the model.
CAUTION
• Do not remove both doors
simultaneously. Make sure to remove
one door at a time. Otherwise, one of
the doors may fall and cause physical
injury.
• Make sure the refrigerator is off before
disconnecting the connectors.
2. Gently draw up the clamp. To prevent
finger injuries, do not apply a sudden
force to the clamp.
3. Pull the clamp to remove it.
NOTE
Be careful not to drop the clamp on the
floor.
4. Open the door 90 degrees. While
holding the door, pull up and remove
the top hinge. Be careful not to damage
the connector wires when you remove
the hinge.
NOTE
Be careful not to drop the hinge on the
floor.
2021-06-07
3:24:54