Publicidad
Idiomas disponibles
Idiomas disponibles
To correct the door gap
CAUTION
The electrical connectors must be left intact during this process. Use caution so you don't
tangle the connector wires or peel off the coating.
Untitled-1 33
Door gaps can be corrected using the
gap bolt on the top right corner of the
refrigerator.
1. With the door closed, use a Phillips
head screwdriver to remove the 6
screws in the top cover. Then, carefully
remove the top cover along with the
wire connectors.
2. Use a 4 mm Allen wrench (not
provided) to correct the door gap
between two doors.
- To widen the gap, turn the gap bolt
clockwise.
- To narrow the gap, turn the gap bolt
counterclockwise.
3. When done, reinsert the top cover, and
then reinsert the screws that hold it in
place. Tighten the screws.
English 33
2018-08-27
6:54:39
Publicidad
