Publicidad
Idiomas disponibles
Idiomas disponibles
ANACO
Use a Phillips-head or flat-head screwdriver for assembly.
1 „ Attach Panels
(1) Match the corner of Back Panel A to Side Panel A
and Front Panel A,
(2) Using Long Bolt for the top
(3) Using Short Bolt for the side
(4) Using Long Bolts for the bottom to attach.
Follow the same steps for the Side Panel B.
How to assemble the}
| How to
Long
Side Panel and Front]
| insert Bolt
Bolt
Panel
Side Panel A
Front Panel A
O For the opening width 35.4 - 45.5"
| D
Remove Nuts (2) and Top Frame of Front Panel B.
RA
Then, take off the one side of Wire Panel from
ジン
Side Panel. Then, attach the other side of Wire
Panel using Nuts (2).
Outside of
Top
tHe Bolt Hole
Inside Of
Outside of
Inside of,
4
À
the Bolt Hole
tHe Bolt Hole
f
Webel oR geP
-
©
NO)
Wire Panel
0/40
Front Panel B
(1) Attach Front Panel A and B using Short Bolt. Then follow the same
2 = Attach Frames
steps for Back Panel A and B.
(1) Position of Bolts
(2) Make sure to tighten the Nuts (16) on Front/Back Panels.
Make sure to check that there are no loosened Nuts.
if
(2) Position of Nuts (16)
Front Panel A
と
Front Panel B p
Short
JF
|
Bolt
Top Frame
Spring Washers
Flat Washers
wz
V
GS
个 ES
xMake sure to insert Bolts at the
Bottom Frame
point shown on the following chart (see page 3) according to the designated width.
3. Attach Trays
The Floor Tray is designed to fit and expand with
Expandable Pet Crate.
Make sure to lap more than 2 rows of grooves
on Upper/Lower Tray as shown.
Upper Tray
Firmly press the front-row convex joint of the
Upper Tray (See the arrows in the figure above)
until both Trays are fixed. (Only the front-row
Lap more than
T
two convex joints
Lower Tray is
convex has joint fixing grooves.)
Y
77
marked "1"here.
Publicidad
