Troubleshooting - Roberts 10-481 Manual Del Usuario

TROUBLESHOOTING TIPS
LOW OVERHEAD CLEARANCE:
If the clearance is between 1/2" and 1-1/2" it may still be possible to move the
appliance:
1. Rapidly switch the blower on and off to provide enough air for
movement without a high and forceful lift.
CAUTION: Rapid Inflation can knock hanging fixtures from chain.
CANNOT SLIDE LIFTING PADS UNDER FRONT:
1. Tilt the front of the appliance by pushing against the top front.
2. Use your foot to slide a 1/2" thick block of wood under one corner.
3. Insert pads.
4. Remember to replace the block under the corner before turning off the
blower, and reverse the procedure.
Extend pads 4" beyond
end of appliance
At least 1-1/2" to 2"
clearance
– 6 –
1/2"
Spacer
10-481_AirGlider_Chart-002.ai