Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING
The desired spray pattern, the amount of paint emitted and the fine atomization can be set on the air
volume regulator, spray jet regulator and paint volume regulator.
Try the settings on a test object such as a piece of cardboard before you start painting.
OPERATION
1 The applied colour layer is thinner
2 The applied colour layer is thicker
When painting, ensure the correct distance of approx. 15 to 30 cm and a guide of the paint spray gun
that runs parallel to the surface. If you handle the paint spray gun properly, you will get the desired
coating. Use the paint spray gun as follows:
1. Hold the handle of the paint spray gun vertically, and then move the paint spray gun parallel to
the surface several times.
2. The painting line should be started before the trigger is pulled and the trigger should be released
before the painting line is finished (see figure above).
3. When painting, keep a distance of approx. 15 to 30 cm between the paint spray gun and the
surface to be painted.
MAINTENANCE
1
Pour the remaining paint into another container.
2
Pour a small amount of thinner into the flow tank and pull the trigger to clean the paint channel.
Thoroughly clean the paint channels before you dismantle the paint spray gun.
3
Use a brush soaked in thinner to clean other areas.
4
Remove the nozzle and the nozzle needle to clean it at the end.
5
Always clean the paint spray gun particularly thoroughly after use.
ATTENTION
● Never spray chemicals through the paint spray gun.
● Never connect the compressed air connection of the paint spray gun to a liquid.
● Never use wire to clean the nozzle as this will damage the nozzle.
● Never immerse the entire spray gun in solvent (thinner). This will damage internal components.
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycling centre
and disposed of in a manner which is compatible with the environment.
Contact your local solid waste authority for recycling information
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Wrong
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Correct
3 Start point
4 Press trigger
.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
5 Release trigger
6 End point
Publicidad
