Publicidad
20
CU1A
CU1A Controls
1
2
3
4
5
(EN) Controls
1. USB C SOCKET – use this socket to connect
2. MONITOR SWITCH – use this switch to turn
3. VOLUME – use this control to adjust
4. PHONES – use this 3.5 mm TRS jack socket to
5. INPUT – use these 3.5 mm TS jack sockets to
6. OUTPUT – use these 3.5 mm TS jack sockets
6
Quick Start Guide
the CU1A to a computer. The CU1A is powered
via USB, and is not connected to the Eurorack
power bus.
direct monitoring on or off.
the headphone volume if monitoring is
switched on.
monitor the CU1A's input using a suitable set of
stereo headphones.
input audio to the CU1A. Mono signals can be
fed to just the L socket.
to monitor the USB audio signal from
your computer via a mixing desk or
powered speakers.
On the rear of the PCB there are two dip
switches for setting the input and output levels
to Lo (-10 dB) or Hi (+4 dB). The two channels
can be set separately.
21
Publicidad
