Publicidad
Idiomas disponibles
Idiomas disponibles
2. ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before
operating the heater.
WARNING: Do not operate without feet attached. Do operate the heater only in
upright position (feet on the bottom, controls on the top), any other position could
create a hazardous situation.
Place the radiator body upside-down on a scratch-free location, make sure it is
Ÿ
stable and will not fall.
Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped
Ÿ
bolt to the U-facing ange between first and second fins (near the front cover).
To attach the castor mounting plate to the radiator body, you should insert the
Ÿ
threaded ends of the U bolt in the holes on the castor mounting plate.
Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Ÿ
Note: do not over tighten, which may cause the damage of radiator flange.
Screw off spherical nut from the castor, align the shaft to the hole of the castor
Ÿ
mounting plate, insert in, and screw on the spherical nut.
Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.
Ÿ
Note: the rear castors must be mounted between the end two fins.
3. INSTRUCTIONS FOR USE
Before using the heater, make sure that it is on a at and stable surface, damage
Ÿ
may occur if it is placed on an incline or decline.
Set all the controls to OFF position and insert the plug into a socket-outlet with
Ÿ
well grounded. Be sure that plug fits firmly.
Rotate the thermostat knob clockwise to MAX position and switch the heater on
Ÿ
as follow: the switch I for low heat, the switch II for medium heat and both
switches on for high heat.
When your room reaches the desired temperature, now slowly rotate the
Ÿ
thermostat knob counter clockwise until the pilot light goes out. The thermostat
can now be left at this setting. As soon as the room temperature has dropped
below the set temperature, the unit will switch it self on automatically until the
set temperature has been reached again. In this way the room temperature
remains constant with the most economical use of electricity.
8
Publicidad
