Levenhuk Ermenrich Wett TU30 Guia Del Usuario página 3

Ermenrich Wett TU30 Thermohygrometer
EN
Please carefully read the safety instructions and the user manual before using this product. Use the device only as specified in the user
manual. Keep away from children.
The kit includes: thermohygrometer, user manual, and warranty card.
Getting started
• Unscrew the battery compartment cover screws and remove the cover.
• Insert 3 AAA batteries, ensuring to observe the correct polarity.
• Replace the battery compartment cover and tighten the screws.
• Press the Power button (6) to turn the device on or off.
Display information
Usage
Attention! If the device gets moved, it is necessary to wait for the readings to stabilize.
After turning the power on, the LCD screen will display the ambient temperature and relative humidity. The screen shows the corresponding
icons for the selected measurement mode.
• Press the °C/°F button (4) to switch between °C and °F.
• Press the DP/WB button (7) to toggle between displaying the ambient temperature, dew point (DP icon on screen), and wet bulb
temperature (WB icon on screen).
▲
• Press the REC/ button (5) to activate the recording mode for extreme and average temperature as well as the humidity values (REC icon
is displayed on the screen). Press the REC/
the screen), and average (AVG icon on the screen) values. To exit to normal mode, press the REC/
• Press the H button (8) to activate data hold mode (Н icon on the screen). The device will display the last recorded values. Press again to
return to measurements.
1 2 3
13
12
11
10
1 Auto-off function
2 Data hold
3 Record function
4 Maximum values
5 Minimum values
6 Average values
7 Low battery
8 Relative humidity
9 Temperature
10 Wet bulb
11 Dew point
12 Readings view
13 Readings record
▲
button (5) to cycle through the maximum (MAX icon on the screen), minimum (MIN icon on
4 5 6 7
3
8
9
▲
button (5) and hold it for 2 seconds.