cecotec BAMBA IONICARE TOOTHCARE JET FRESH Manual De Instrucciones página 48

ENGLISH
Removing scale
- Depending on the mineral content of the water used, limescale deposits may build up in
the appliance. If you do not remove limescale deposits, they will reduce the performance
of the product.
- Point the tip to the sink, turn on the device and let it run until it has emptied all the water.
Fill the water tank with clean, warm water and repeat the previous step to clean the tank.
This cleaning process must be repeated every 1-3 months to keep the performance of the
product.
Battery maintenance
- Make sure that the battery is completely charged before using it for the first time.
- Make sure the battery is fully discharged before storing the appliance for a long period of
time.
- To lengthen the battery autonomy, charge the device immediately when battery is low.
5. TROUBLESHOOTING
Problem
There is a leak between the
tip and the body
There is a leak in the water
inlet
There is a leak in the water
tank
There is not enough water
pressure
The device does not turn on
48
BAMBA IONICARE TOOTHCARE JET FRESH
Possible cause
Tip improperly installed.
The tip holder seal is
damaged.
The seal is damaged, or there
are impurities in the inlet
The cover gasket is damaged
or incorrectly fitted.
There is not enough battery.
There is not enough battery.
Possible solution
Remove the tip and install it
again in its position, ensuring
it correctly fits.
If the problem persists,
contact the official Technical
Support Service of Cecotec to
repair the seal.
Contact the official Technical
Support Service of Cecotec to
repair it.
Position the gasket properly
or contact the official Cecotec
Technical Support Service to
replace it.
Try again after charging.
Try again after charging the
device.