Publicidad
Idiomas disponibles
Idiomas disponibles
You may use this hedge trimmer for the purposes listed
below.
• Trimming hedges, shrubs, and bushes with branch
diameters less than 5/8".
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Securely tighten all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced.
USING THE HEDGE TRIMMER
WARNING:
before each use. Remove all objects such as cords,
lights, wire, or loose string which can become entangled
in the cutting blade and create a risk of serious personal
injury.
• Before starting the hedge trimmer, maintain proper
footing and balance and do not overreach. Wear safety
goggles, non-skid footwear and rubber gloves.
PROBLEM
Motor fails to start when
switch is depressed.
Motor runs but cutting blades
do not move.
Hedge trimmer smokes during
operation.
Motor hums, blades do not
move.
CLEANING
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
fluids, gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
APPLICATIONS
Clear the area to be cut
TROUBLESHOOTING
POSSIBLE CAUSE
Battery is not secure.
Battery is not charged.
Hedge Trimmer damaged.
Hedge Trimmer damaged.
Debris or other may be jamming
the
blades.
MAINTENANCE
Do not at any time let brake
• Hold the unit with both hands with the cutting blades
directed away from you. Always use the hedge trimmer
properly.
• Do not trim too much at one time. This can cause the
blades to bind and slow, reducing the cutting efficiency.
• Do not force the hedge trimmer through heavy
shrubbery. This can cause the blades to bind and slow
down. If the blades slow down, reduce the pace of your
work.
• Always cut stems or twigs that are less than 5/8" thick.
Use a non-powered hand saw or pruning saw to trim
large branches.
• When trimming new growth, use a wide sweeping
action, so that the stems are fed directly into the cutting
blade. Older growth will have thicker stems and will be
trimmed most easily by using a sawing movement.
• Always hold the hedge trimmer with both hands when
operating. Use a firm grip on the handles. The unit is
used for cutting in either direction in a slow, sweeping
action from side to side.
To secure the battery pack, make sure
the latches on the top of the battery pack
snap into place.
Charge the battery pack according to the
instructions included with your model.
Call for Genesis technical service.
Do not use hedge trimmer.
Call for Genesis technical service.
Do not use hedge
Remove battery, clear debris blockage
from blades.
Electric products used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the
fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently, we do
not recommended using this product for extended work on
these types of materials. However, if you do work with any
of these materials, it is extremely important to clean the
product using compressed air.
ENGLISH
SOLUTION
trimmer.
Publicidad
