Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Installing the stroller kit (10045937 & 10045938)
Fix two handle receivers onto the rear tubes of frame by tightening the nuts. On handle ends,
press the spring buttons in and slide the handle into handlebar receivers until two spring
buttons pop up through the holes (Figure 11). To remove handle, push buttons in and pull up
on handle.
Insert the rectangle tube on the front wheel into the rectangle holder underneath the front
frame of the trailer. Make sure that holes on both rectangle tubes line up. Lock the front
wheel using the quick release skewer (Figure 12).
IMPORTANT: Tow bar must be removed before using the stroller kit.
Figure 11
Figure 12
Assembled Trailer
10045935 & 10045936
10045937 & 10045938
25
Publicidad
