Descargar Imprimir esta página

Bestron COPPER ASM500CO Manual De Instrucciones página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
OPERATION - General information
The below description goes with the image on page 2.
1. Adjustable speed controller
2. Pulse button (I)
3. Pulse button with turbo function (II)
4. Motor housing
5. Blender
6. Cables and connectors
1. Take the appliance out of the packaging.
2. Clean the appliance (see 'Cleaning and maintenance').
The mixer is particularly suitable for preparing purees, sauces, dips, soups, mayonnaise and baby food. It
is also suitable for mixing drinks and milkshakes.
The device is equipped with an adjustable speed controller and two pulse buttons. The pulse button (I)
serves as an on/off switch and the pulse button (II) serves as a turbo function.
3. Install the rod to the motor housing by turning it clockwise until it clicks.
4. Put the ingredients to be mixed in a bowl. Make up with a small amount of moist substance such as milk,
juice, or water to make mixing easier.
5. Potatoes and vegetables can be pureed in the saucepan, but the saucepan must first be removed from the
heat source and be put on a flat and stable surface.
6. Next, insert the plug into the plug socket.
7. Hold the Hand Blender upright in the bowl or pan.
8. Switch on the device by pressing one of the 2 pulse buttons. Use the adjustable speed controller (1) in
combination with the pulse button (I) (2). First, press the pulse button (I) and turn the speed control left or
right to determine the speed. The pulse button with turbo function (II) (3) can be used to mix at the fastest
level.
9. The device will automatically turn off when the pulse button is released.
10. Remove the plug from the socket.
WARNING:
Never turn on the mixer if the mixing stick is not in the bowl/saucepan. Otherwise, the sharp knife may
cause serious injury.
The mixer may not be used for more than one minute without stopping. After that let the appliance cool
down to room temperature.
During use, hold the bowl/cup/pan so that it cannot slip off the work surface. Remember that the pan
may still be hot!
CLEANING AND MAINTENANCE
1. Remove the plug from the wall socket and allow the appliance to cool down sufficiently.
2. Remove the rod from the motor housing by turning it counter-clockwise.
3. Put the hand blender in a cup half filled with warm water. Hold the cup firmly and turn on
the device for a few seconds. The knives have now been cleaned.
4. The stickmixer can be cleaned by rinsing it with running tap water. Dry it thoroughly.
5. Clean the appliance's motorunit with a damp cloth. After cleaning, dry the unit thoroughly.
6. Store the appliance.
WARNING:
Be careful with the sharp knife during cleaning.
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
14
14
EN
EN

Publicidad

loading