Descargar Imprimir esta página

Moretti MOPEDIA RP780 Manual De Instrucciones página 17

Sillas multifunción para baño

Publicidad

Idiomas disponibles

Idiomas disponibles

10. ASSEMBLY INSTRUCTION
RP780
Insert the toilet support to the product which is supplied already assembled,
making sure to fit correctly the support with the horizontal rear bar.
RP781
Open the sides of the frame, lift the part with the toilet support already
assembled and fix the two ends to lateral parts. Next, install the rear bar.
RP782
Insert the two horizontal bars in the supports of the side parts making them
block thanks to the safety clips. Insert the toilet support paying attention to fit it
properly with the horizontal rear bar.
RP783
Insert the toilet support paying attention to fit it properly with the horizontal rear bar.
Insert the backrest bar upwards into the holes of the rear rails making it block thanks
to the safety clips.
11. SEAT
(fig.1)
11.1 To lift the armrest (only for rp763)
Swing the armrest upward inserting them in the safety clips. (fig.1)
11.2 To lower arms (only for rp763)
Press the safety clips inward and swing the armrest downward. (fig.2)
NOTE Before you sit down:
- Place the product on a flat and solid surface and if present, lock the brakes of the castors
- Make sure that the lock latch is secure and that the product is in a stable position
12. USING WARNINGS
Use caution on wet and slippery surfaces
DO NOT use with patient who exceeds the weight indicated in the product
label and in the technical features chapter of the present manual
Press the safety clip to adjust the height of the chairs
by removing the inner part of the leg and bringing the
holes to the desired height. Check that all four legs are
adjusted to the same height.
(fig.2)
(Picture with illustrative purpose only)
5

Publicidad

loading

Este manual también es adecuado para:

Mopedia rp781Mopedia rp782Mopedia rp783