Publicidad
Idiomas disponibles
Idiomas disponibles
4. Wall-mounting procedure
Warning
Confirm that the wall is strong enough to support the weight of the enclosure
with all the loads. Failure to follow these procedures may result in personal injury
damage to the equipment.
Phase
Image
1
2
5
Mounting step
Preliminary steps
1. On the rear wall of the enclosure are 4 mounting holes.
2. Choose a mounting position and with the supplied template,
proceed to mark the locations of the holes on the wall surface.
3. Drill a pilot hole in the center of each mark using the hand-held
tool.
Note: prior to drilling the holes, confirm that the markings are
accurately leveled to avoid destabilizing the entire structure.
4. Drive the anchors and bolts into the predrilled holes on the wall.
Leave a small clearance (¼in) between the surface and the bolt
heads to allow hanging the enclosure into position.
Mounting the enclosure to the wall
1. Once the bolts are properly secured, align the enclosure frame
with the anchor bolts installed.
2. Carefully slide the enclosure into its final mounting position.
3
Ground connection
1. Connect the first grounding cable to the door using the provided
hardware.
2. Likewise, connect the second grounding cable to the side panel
using the hardware provided.
3. Using the self-tapping screw bind both grounding cables to the
closest mounting hole on the right side horizontal beam.
4. Then, connect the grounding cable to the left side panel on the
rear section of the cabinet.
5. Using the self-tapping screw, bind the grounding cable to the
closest mounting hole on the left side horizontal beam.
Note: fully-tighten the screws only after all the screws have been
inserted.
6
Publicidad
