Grote 79276 Serie Guia De Instalacion

Please Note: These instructions are provided as a general guideline only. Specific mounting, wiring, and/or weather-sealing may be necessary and are
the sole responsibility of the installer. The manufacturer assumes no responsibility for the integrity of the installation for this or any of its products.
•
Improper installation may result in serious injury, property damage, or death. The installer must have a good understanding of automotive
electronics, systems, and procedures.
•
If you are drilling any holes while mounting this light, please be sure to check both sides of the surface to ensure that you do not damage anything.
De-burr all holes.
•
Ensure that any switches used are located in an area that allows the vehicle and device to be operated safely in any driving condition.
•
Use a minimum 18AWG wire for electrical connections and a 10A fuse at the power source, ensuring both positive and ground connections are
dependable.
•
Test the light and inspect all wiring each time you use the vehicle to ensure that it is functioning properly. If it is not functioning properly, do not
operate the vehicle!!
•
Use only soap and water to clean this product. Use of harsh chemicals could cause the domes to haze and may lead to diminished light output
reducing the effectiveness. Do not use a power washer to clean this product.
When wiring your lights, it is recommended that you take the following precautions to reduce any Electromagnetic Interference (EMI).
• Keep LED modules and any radios as far away from each other as possible.
• Separate the radio wires and the LED wires.
• Any excess wires should be cut short.
• The GROUND and POWER wires should be bound tightly together as they run from light to light, through your switchbox, and to the battery.
• Do not ground each unit independently to the chassis. Run the ground for each unit in a "bus" like structure, to the negative terminal on
the battery.
Note: Lights must be mounted a MINIMUM of 12" apart.
Several mounting brackets are available if mounting directly to the surface is not desired.
Please visit our website for a complete list of brackets.
For surface mounting, use the gasket as a template to mark and drill three 1/8" holes for
the self tapping screws and wires.
MUST DRILL HOLES THE SPECIFIED SIZES!!!
DO NOT OVER TIGHTEN SCREWS!! TORQUE TO 10 IN.-LBS.!!
MUST USE #6 STAINLESS STEEL SCREWS!!
Unless you are using the optional shims, this light must be
mounted on a perfectly flat surface!! Failure to do so will
result in damage to the housing and will void the warranty!
If you are installing this light on a curved surface, it is recommended that you purchase the #30019-314 Shim Kit
and install the shims as pictured to the right.
Once the wires are run, the use of a small amount of silicone or other similar sealant (not included) is
recommended to seal the wire hole and prevent your wires from becoming damaged.
DO NOT stand within 7" of the light when it is illuminated!!
Note: Auxiliary light does NOT illuminate all objects.
This light utilizes high frequency LED lamps. DO NOT stare directly into the light while it
is on, as momentary blindness and/or permanent eye damage may occur.
Wiring Notes
Surface Mounting Instructions
Low Profile Steady Burn LED Auxiliary Light
MINIMUM 12"
Rubber Mounting Gasket
P30047-174
Remove the one gasket slit that is open to the bottom and ensure it
is aligned with the Gortex™ pad on the rear of the light. This will
allow air to circulate through the pad, helping reduce condensation.
Installation Guide:
79276 Series
PLIT624GROTE REV. - 3/13/24