cecotec POWERTWIST BATTERY Manual De Instrucciones página 23

- Please note that neither the mixer nor its charging base is waterproof.
- It is recommended to let the appliance rest for 1 minute for every 3 minutes of operation. If
you use it three times (stopping for 1 minute between each use), you will have to let it rest
for half an hour before using it again.
- Use a 5V-2A adapter to charge the appliance at optimum speed. The full charge cycle will
take 4 hours.
1. Before using the mixer, clean the beaters and make sure that it is fully charged.
2. Place the body on its charging base. Turn it until you hear a click. Fig. 2
NOTE: you will also hear a click when inserting the accessories.
WARNING: do not insert any metal knives, spoons or forks into the bowl when using the mixer.
4. OPERATION
NOTE: make sure the mixer is off before inserting or removing the beaters.
Operation
1. It is recommended to charge it fully before the first use. Fig. 3
2. Insert the stainless steel beaters into the holes. Fig. 4
3. Move the knob to switch on the appliance. Fig. 5
4. Turn the knob to set the speed. Fig. 6.
5. When the appliance is on, you can set the knob to the 0 position to pause it. Fig. 7
6. Switch off the mixer before removing the beaters. Fig. 8
NOTE: turn the knob clockwise to increase the speed or counterclockwise to decrease it.
WARNING: before removing the accessories, make sure the mixer is switched off.
Accessories assembly
1. Make sure the hand mixer is disconnected from the mains.
2. There are two different beaters, one of type A and one of type B. Fig. 9
3. Insert the stainless-steel beater without collar (A) into the left opening (C) and the
stainless-steel beater with collar (B) into the right opening (D). Fig. 10
4. Align and push to fit. Both stainless steel beaters will fit.
5. Make sure the accessory is properly fitted into place and securely fixed.
ENGLISH
POWERTWIST BATTERY 23