Publicidad
Idiomas disponibles
Idiomas disponibles
3. Connect the other end of the USB cable (not included) to
the USB charging port. Then press the UV light or LED light
switch to start charging the device (Fig. 8).
Fig. 8
USB-C
USB-A
4. After charging, remove the USB cable, then put the rubber
USB ports cover protector back into place.
Cleaning the Collection Tray
1. Open the bug collection tray to 60º, and then clean the tray
with the cleaning brush. Avoid touching insects by hand.
2. Close the collection tray back into the housing (Fig. 9).
Fig. 9
Bug collection tray
Maintenance
Please contact an authorized All Season Power dealer or call
the All Season Power customer service center at
1-866-225-9723 for all maintenance operations not detailed in
this manual. Any operation performed in an unauthorized service
center or by unqualified personnel will completely invalidate the
warranty.
m
WARNING!
To avoid serious personal injury, always
remove the battery pack from the product when cleaning or
performing any maintenance.
m
WARNING!
When servicing, use only identical
replacement parts. Use of any other parts could create a hazard
or cause product damage.
NOTE: Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
Please contact customer service or a qualified service center for
assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
m
WARNING!
Do not at any time let brake fluids, gasoline,
penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken, or destroy plastic, which may
result in serious personal injury.
BULB REPLACEMENT
1. Unscrew the two M5 screws from the bug zapper top and
remove the upper cover of bug zapper.
2. Take out the old UV light upward; insert the new UV light
downward.
3. Reassemble the upper cover with M5 screws (Fig. 10).
Fig. 10
10
M5 screws
UV light
Publicidad
