Publicidad
Idiomas disponibles
Idiomas disponibles
Figure
Figure
Low Battery Indicator
Figure
ZCTLU861CE Rev B
7: CTLU861
8: CTLUH861
9: CTLU861
Figure
• LED Location - When the red LED starts to flash, this
indicates the battery needs recharging, otherwise the
worklight will shut off in approximately ten (10) minutes.
Battery Charging
Figure
11: Inserting the Battery Pack into the Charger
1. If charger is supplied with a separate charger cord, plug
cord into charger.
2. Plug the other end of charger into the AC power source.
3. Insert battery pack in charger. Press lightly on battery
pack until it stops. The charger is equipped with a 4-LED
fuel gauge that indicates 25%, 50%, 75% and 100%
state of charge. When the battery makes contact, all 4
green LEDs on the fuel gauge of the charger will flash
twice and then the charger will step through the 4 LEDs
and stop at the one flashing green LED that signifies the
battery state of charge and that the battery is charging.
4. Certain built-in safety protections may lock the charger
off. If no charger light illuminates, remove the battery
and unplug the charger for 10 minutes. Plug the charger
back in and insert a known good battery. If no light
comes on the charger is faulty and must be replaced.
8
10: CTLUH861
(10/20)
Publicidad
