Publicidad
Idiomas disponibles
Idiomas disponibles
FAN CONTROL MODULE
Fans are pre-wired to Control Module as shown, labeled directly on top of Module. (FIGURE E)
NOTE: Location of wires to Control Module are specific to polarity which is shown
on the top of the Module
NOTE: Select the appropriate wall plug adapter supplied with the power supply for your region, and install
into the power supply. Connect power supply to power source.
To remove a wall plug adapter, press tab labeled PUSH while simultaneously turning plug
counterclockwise and lift out. To install a wall plug adapter, properly orient the wall plug adapter and
insert into the power supply, and turn plug slightly clockwise until a clicking sound is heard.
"ALWAYS ON" FAN OPTION
To have your fan tray power run at all times (regardless of the temperature), remove the temperature
probe/thermistor, and replace it with a bypass loop as shown. The unit will then run whenever it is
connected to a power supply. Save temperature probe/thermistor for later use. (FIGURE F)
NOTE: If the tray is used in the rear of the rack to reduce static pressure, the temperature probe/thermistor
should be placed near the top of the rack where the heat rises
Bypass
Loop
OPTIONAL FAN KIT
Additional fans may be added to have a total of 8 fans in tray. Part Number: FT-FAN
(FIGURE E)
Strip
to Here
9.5 mm
(FIGURE F)
Page 10
Top View
Bypass
Loop Wire
50 mm Approx.
Strip
to Here
Publicidad
