Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
2
Removing the existing doorbell
□
Remove the cover from the existing doorbell
and label all wires with masking tape before
disconnecting:
□
"F" - Front door push button wire
□
"T" - Transformer wire
□
"R" - Rear door push button wire (if
applicable)
□
Disconnect all wires from the existing doorbell
and remove the doorbell from mounting surface.
3
Mounting the doorbell base
NOTICE: Remove ALL packing materials, including rubber bands,
before installing.
□
Route the wires through the wire entrance hole
in the doorbell base (B).
□
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the two screw hole locations.
□
Drill two 7/32 in. pilot holes and insert wall
anchors (BB).
□
Attach the doorbell base (B) to the mounting
surface using the two screws (AA) and tighten
securely.
4
Wiring the doorbell
□
Connect the doorbell wires to the doorbell
base (A):
□
Wire "F" to screw terminal "FRONT"
□
Wire "T" to screw terminal "TRANS"
□
Wire "R" to screw terminal "REAR"
□
Press the doorbell cover (A) onto the doorbell
base (B).
NOTE: To remove doorbell cover after doorbell base is
mounted, firmly grasp doorbell cover and pull.
NOTE: Push button(s) wired to the screw terminal
marked "FRONT" will play the "Ding-Dong" sound. Push
button(s) wired to the screw terminal marked "REAR" will
play the "Ding" sound.
5
Please contact 1-866-308-3976 for further assistance.
B
AA
B
HOMEDEPOT.COM
Publicidad
