Step 5: Use
Push the button upward to start the equipment. If you need to pause
during use, push the button downward. If you want to continue to use it,
push the button upward again. This product has 70-second timed
shutdown function. Before the equipment shuts down automatically, the
water in the water tank will be used up. If you need to continue to use it,
push the button downward to shut down, add water and then start the
equipment again. Turn off the equipment after using.
Techniques
For best results, start with the molars (posterior teeth) and start cleaning
towards the front teeth. While cleaning, move the nozzle 90° along the
gum line. Stay between each tooth for a short period. Close your lips
slightly to avoid the water from spraying out, but leave enough space so
that water can flow freely from your mouth to the sink.
Step 6: After Use
After using, open the water tank cover with the water entry hole facing
the ground, and pour out the remaining liquid in the water tank. Turn on
the equipment, drain any liquid left until the irrigator no longer drains
any liquid, and then turn off the equipment.
11
IV. Cleaning and Maintenance
Cleaning the Body:
1. Clean this device only with clean water or a neutral detergent. Do not
use corrosive or abrasive detergents.Do not use water above 50℃ to
clean any part of this device, as this may lead to damage or reduced
performance.
2. Do not soak the oral irrigator in water. If necessary, clean the surface
of the device by wiping with a soft cloth dipped in mild, non-corrosive
detergent.
Cleaning the Tank:
1. Remove the water tank.
2. Rinse the inside of the tank with clean room temperature water. Do
not clean the tank with any type of detergent.
3. Reinstall the water tank after it has been cleaned.
Removing Hard Water:
1. Depending on the mineral content of the water used, hard water
deposits may build up on the device. Failure to remove hard water
buildups will reduce product performance.
2.Point the nozzle at the sink, turn on the device, then let it run until all
water has been used. Fill the water tank with clean warm water, then
repeat the above steps to clean the tank. This cleaning process should
be repeated every 1-3 months to maintain product performance.
12