Osborne MPV1024 Instrucciones De Manejo página 5

PO ot i ee a es
Safety Precautions &
Maintenance
@ The rear panel should only be removed by a
service technician.
® |fnecessary, clean with a slightly damp
sponge. Do not use alcohol or ammonia.
® Never expose the monitor to rain or excessive
moisture to reduce the risk of fire or shock.
Re ease eae
Technical
Information
(I) General specifications:
Picture tube 14 inch, 90° deflection,
non-glare, black matrix,
light transmission 57%,
dotted pitch 0.28 mm.
Line(Horizontal)
frequency 31.5 / 35.2 / 35.5 KHz
Raster(Vertical)
frequency 50 - 87 Hz
Mains voltage * 220 - 240 VAC
Power
consumption : 80 watt typical
Video bandwidth: 32 MHz, at -3 dB
Resolution
(1) VGA mode, horizontal freq. at 31.5 KHz;
non-interlace.
640 x 350 pixels (EGA emulation), 70 Hz.
640 x 400 pixels (VGA), 70 Hz.
640 x 480 pixels (VGA), 60 Hz.
(2) VGA Plus mode, horizontal freq. at 35.2 KH
non-interlace.
800 x 600 pixels, 56 Hz.
(3) IBM 8514A mode, horizontal freq. at
35.5 KHz; interlace.
1024 x 768 pixels, 87 Hz.
Unit dimension
(Hx Wx D)
Net weight
359 x 356 x 395 mm
14 Kg
(
©
¢
© ¢
|
(Il) Input signal:
Analog RGB input via 15-pin D-shell signal cable,
pin assignment as_ follows:
PinNo. Assignment
1 Red video input
2 Green video input
3 Blue video input
4 Ident output
- connected to pin 10
5 Self-test input
6 Red video ground
if Green video ground
8 Blue video ground
9
0
1
Not connected - no pin
1 Logic ground
1 Ident output
- connected to pin 10
12 Ident output
- not connected
13 Horizontal Syne
14 Vertical Sync
15 Not connected
* Because of a policy of continuous product
improvement , the above specifications are
subject to change without notice.