Publicidad
Idiomas disponibles
Idiomas disponibles
Rear part
of the body
Stop
Front part
of the body
white. If the electronic lid is in standby mode, i.e. not used and seat heating is off, then
the backlight glows blue.
Rear part of the body/Front part of the body
Rotating forward, without pressing, the nozzle moves out and begins to work to wash
the front part of the body. It starts working with standard (central) default settings.
Turning back without pressing, the nozzle moves out and starts working to wash the
rear part of the body. It starts working with standard (central) default settings.
Nozzle position adjustment
In front or rear wash mode, the nozzle moves forward when the controller TouchReel
rotates forward, the nozzle moves back when the controller TouchReel rotates back.
Each time you start to rotate the controller, the nozzle moves 1 step. To take the next
step, stop rotating for approx. 0.3 sec and start rotating the controller again.
In front or rear wash mode, a short press on the controller means stop.
Setting water pressure
After a long press on the controller TouchReel (approx. 2 sec.), water pressure
Adjustment mode is activated: the flow increases, when the controller rotates forward,
the water flow decreases when the controller rotates back. Each time you start rotat-
ing the controller, the water flow is increased/reduced by 1 step.
To take the next step, stop rotating for about 0.3 sec and start rotating the controller
again.
Night light switch on/off method
In the non-seated state, press and hold the TouchReel side control knob for 2 seconds.
After hearing a long beep, the night light function is turned on or off.
Side controller has a 10-second memory for adjustment of nozzle position, pressure and water tem-
perature. If, within 10 sec from the last use, the procedure is restarted, the seat will begin to work
with the same settings. If more than 10 sec have passed since the last use, then the seat will begin
to work in the mode of average settings for temperature and water pressure.
TouchReel side control knob
When connecting for the first time, the seat
performs a self-diagnosis and flushing
of the system. At this time, the backlight
around the side controller lights up in
white. When diagnostics and flushing are
completed, the backlight changes color to
blue. If the electronic lid is in active mode,
i.e. the user is sitting on the seat or seat
heating is on, then the backlight glows in
37
Publicidad
