Publicidad
Idiomas disponibles
Idiomas disponibles
TO PREVENT ELECTRIC SHOCK, this fan has a two-prong
plug that must be inserted into a matching, properly
grounded outlet. This fan has also been equipped with a
polarized plug (one blade is wider than the other). This
reduces the risk of electric shock or fire by ensuring it
can only be plugged in one way. If the plug does not fit
fully into the outlet, reverse the plug. If it still doesn't
fit, have a licensed electrician change your outlet. Do
not attempt to defeat this safety feature.
Do not operate this fan if it has any visual defects. For
repairs under warranty, contact FanFair's Customer
Support for assistance.
How To Assemble:
1. Unscrew the blade cap by turning clockwise.
2. Mount the rear safety grill to the motor by
matching the 3 pins to the 3 holes in the safety
grill.
3. Tighten the rear safety grill with the nut. Tighten
until the flush with the outside motor housing
cylinder.
4. Insert the fan blade onto the motor shaft by
matching the slots in the blade with the pins on
the shaft. Tighten the blade with the blade cap by
turning counter-clockwise.
5. Test the fan by turning the blades by hand to
ensure the blades turn freely.
6. Place the front safety grill by inserting the hook of
the front grill on the rear grill. Secure by closing
the 3 clips.
How To Oscillate:
The oscillating control button is located on the top of
the motor housing. Simply press down to oscillate and
lift up to stop the oscillation.
Cleaning:
CAUTION: Before cleaning the fan, be sure to
disconnect the power cord. Clean the grill with a clean
damp cloth. Do not use harsh chemicals or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Replace the front grill before using the fan
again. Allow the fan to dry completely before use.
Periodic cleaning with a vacuum will help prevent dust
build-up. The motor is sealed and does not require any
further lubrication.
Storage:
Keep the original carton for storing the fan. Coil and tie
the power cord to avoid damaging the cord.
Replacing The Fuse:
1. Disconnect the power cord from the outlet.
2. Open fuse cover by sliding the fuse access cover
open. (fig 2)
3. Carefully remove fuse.
4. Replace fuse with an identical model. Use a 5.0 A,
125 V (3.6mm x 10mm) fuse only.
5. Close fuse access cover.
Questions? Comments?
Visit us at www.ImpeccaUSA.com or call us at 1-866-
954-4440 Monday-Friday 9AM - 6PM EST.
Publicidad
