SurfaceMaxx SMX-PWA104 Hoja De Instrucciones página 7

ASSEMBLY
SURFACE PREPARATION:
1. Clear any loose debris from the area to be cleaned.
2. Never attempt to clean a surface with objects that protrude from the surface being cleaned.
Striking any raised obstacle during operation will damage the machine. If contact does occur and
results in vibration while operating, STOP and replace the spray bar.
CAUTION: RISK OF INJURY OR DAMAGE TO MACHINE!
Never operate the unit if it begins to vibrate! Shutdown the unit and inspect for damage.
PRE-START INSPECTION PROCEDURES:
1. Inspect surface cleaner before each use. Tighten spray bar, bolts and fittings as needed.
2. Ensure all connections are secure. Turn the water supply completely "ON". (DO NOT START
PRESSURE WASHER!)
3. Inspect hoses for kinking, cut or leaks. If a leak is found, DO NOT USE HOSE! Replace damaged
hoses before starting.
4. Unlock the trigger gun and squeeze the trigger. Water will begin flowing from the nozzles of the
surface cleaner. Ensure nozzles are not clogged and spray pattern is not erratic. Change or clean
nozzles before proceeding if problems exist.
5. Be sure that all damaged parts are replaced and that the mechanical problems are corrected prior
to operation. If you need assistance, call our customer service department at +1 (866) 870-9930,
9 a.m. - 5 p.m., EST, Monday - Friday.
OPERATION
WARNING:
DO NOT attempt to operate this walk-behind surface cleaner until you have read and understood
all safety warning and instructions listed in this manual.
Incorrect operation of this unit can cause serious injury! DO NOT alter or modify this equipment in
any manner.
START-UP:
1. Lock the trigger gun on the surface cleaner by moving
the trigger lock to a 90° angle so it rests against the
handle grip (See Figure 10).
2. Ensure all connections are tight.
3. Turn on the water supply.
4. Release the trigger lock and run water through the
surface cleaner.
5. Start pressure washer according to manufacturer's
instructions.
SHUT-DOWN AND STORAGE:
1. Turn the pressure washer off.
2. Turn the water supply off.
3. Squeeze both trigger guns to relieve the water pressure.
4. Disconnect and drain the water inside the pressure hoses. Wipe down the unit and store in a
nonfreezing environment.
Figure 10
7
Trigger Lock
www.surfacemaxx.com