Aiwa MW-200SL Manual De Instrucciones página 5

explode, even after microwave heating
has ended.
8. Failure to maintain the oven in a clean
condition could lead to deterioration of
the surface that could adversely affect
the life of the appliance and possibly
result in a hazardous situation.
9. The appliance must not be placed in a
cabinet.
10. Care should be taken not to displace
the turntable when removing
containers from the appliance.
11. The appliance shall not be cleaned
with a steam cleaner.
12. The appliance must not be installed
equal or higher than 900 mm above
the floor. Minimum height of free
space necessary above the top surface
of the oven: 100mm.
Warning: When the appliance is
operated in the combination mode,
children should only use the oven
under adult supervision due to the
temperatures generated.
CAUTION: HOT SURFACE
13. If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or a similarly qualified
person in order to avoid a hazard.
14. This appliance can be used by children
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
INSTALLATION
1. Take out all the packing. If there is a
safe film over the oven, tear it off before
use. Check carefully for damage. If any,
immediately notify dealer or send to
the manufacturer's service center.
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
15. Children shall not play with the
appliance.
16. Cleaning and user maintenance shall
not be made by children without
supervision.
17. Do not directly put cold water into the
glass plate after use. It needs to place
the glass plate for at least 20 minutes,
and then put it into the water to avoid
cracking.
18. Group 2 Class B appliance
Group 2 ISM equipment: group 2
contains all ISM equipment in which
radio-frequency energy is intentionally
generated and/or used in the form
of electromagnetic radiation for the
treatment of material, and EDM and
arc welding equipment.
Class B equipment is equipment
suitable for use in domestic
establishments and in
establishments directly connected to
a low voltage power supply network
which supplies buildings used for
domestic purposes.
19. This product internal light source LED
light on < 60lm.
20. To be in compliance EN 61000-3-11, the
product shall be connected only to a
supply of the system impedance: |Zsys|=
0.40089 ohms or less. Before connect
the product to public power network,
please consult your local power supply
authority to ensure the power network
meet above requirement.
2. Microwave ovens must be placed
under dry and non-corrosiveness
environments, kept away from heat
and humidity, such as gas burner or
water tank.
EN
MW-200SL 5