Publicidad
LED Light
Mannual
Sticker
Illustrations
Green Light
Yellow Light
Red light
2. Mode introduction
Mode
M1
M2
a. Smart Control Mode
1.
Smart Control mode light is on in Smart Control
mode as Fig. B
B
EN
M1
M2
M1
M2
2.
When a electrical device is plugged in, the AC
Power management device will provide power
from "1" socket to "4" socket in order while
charging.(Note: Smart Control mode powering
priority:outlet 1>2>3>4)
3.
During the Smart Control mode, when one outlet
power is less than or equal to 240W, then this
outlet will stop charging and power will go to the
next outlet.
4.
When each outlet power is less than or equal to
240W, the outlets will be charged at the same to
reach 100% power.
NOTE:
1. The Smart Control mode is suitable for charging
multiple high-power electrical devices and
ensuring that the home circuit does not trip.
2. LED light of the charging outlet is green while
other LED lights still keep yellow.
6
Status
Charging
Waiting for charging
Outlet fault
Mode Introduction
Smart Control Mode
Standard Mode
3. The default mode upon startup is the smart
control mode.
Take examples for explanation as below.
Example 1: Connect three electrical devices to
the AC Power Management Device (240W < Single
electrical device power ≤ 3500W).
LED Light Sticker
C1
M1
M2
Step1:Single electrical device power>240W, so
outlet 1 will charge first(single outlet charge, others
will charge sequentially).(See Fig. C2)
Step2: Automatically switch to outlet 3 after outlet 1
finished (outlet 1 power will drop below 240W). And
so on,1->3->4.(See Fig. C2)
C2
LED Light Sticker
Step3: When each outlet power drop below 240W, 3
outlets will connect in turn and enter into the floating
charging stage, all lights are on.(See Fig. C3)
Mannual Illustrations
Green Light
Yellow Light
Mannual Illustrations
Green Light
Yellow Light
Publicidad
