Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
EMPTY BUCKET LIGHT
If this light is on, the fan and the compressor will stop running. This light indicates that you need to check:
□ If the bucket is full, empty and re-install bucket. If the bucket is not in position, remove the bucket and re-install it.
Make sure the bucket fits all the way into the dehumidifier and the bucket light is off, or dehumidifier will not run.
FAN SPEED
□ Press FAN to select fan speed.
□ Choose LOW, HIGH or AUTO.
FAN
□ LOW - Reach the desired humidity setting with lower sound level.
□ HIGH - Will more quickly reach the desired humidity setting.
□
AUTO - Achieves set humidity at normal speed.
NOTE:
off periodically. The fan may periodically turn on, to read the humidity level, without the compressor running.
HUMIDITY LEVEL
□
Press the Plus or Minus button to set the desired humidity level. Desired humidity in the digital display will flash
HIGH
/ÉLEVÉ
for 5 seconds after operation.
□ Actual room humidity will be displayed after 5 seconds of flashing the desired humidity.
FAN
LOW
/FAIBLE
/VENT.
NOTE: Humidity can only be adjusted manually in Manual Set mode. In Continuous and Auto Dry mode,
humidity level is set automatically.
DIGITAL DISPLAY
Display shows relative humidity or time (depending on setting).
□ When the dehumidifier operates in Manual Set mode, the display shows the relative humidity of the room.
□ When the timer is selected, the display shows the time when the dehumidifier will turn on or turn off,
depending on the setting.
TIMER
To set Timer for a 30-minute to 24-hour delay before the dehumidifier is turned off (the dehumidifier must be On):
□ Press TIMER. Timer indicator light will come on, and the display will flash. The display will show remaining time
before the dehumidifier wiII turn off.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with previous setting:
□ Turn off the dehumidifier.
□
Press TIMER. Timer indicator light will flash. The display will show remaining time before the dehumidifier will
turn on.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To clear the Timer delay program:
□
Press TIMER once after it has been programmed. Display will show remaining time. While the display is showing
the remaining time, press TIMER again. Timer indicator light will turn off.
NOTE: Dehumidifier can be either on or off.
To see the remaining time:
□ Press TIMER once after it has been programmed. Display will show remaining time.
NOTE: Empty the water bucket before setting the timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light goes on and dehumidification stops.
Once the relative humidity of the room hits the desired setting, the compressor will stop and the fan will be
10
Publicidad
