Publicidad
Idiomas disponibles
Idiomas disponibles
1
B. DUO-LOK QUICK CONNECT BUCKLES (FIGURE 8B)
1. Engage: Insert the tab into the receptor. You should hear a click when the buckle is secured.
2. Disengage: Squeeze the lock levers on either side of the receptor. Pull the tab out of the receptor.
3. Adjust: Unlock the webbing lock, then turn and hold the buckle 90 degrees from the harness strap. To shorten
webbing, pull down on the adjustment strap. To lengthen webbing, pull upwards on the buckle.
;
The webbing lock only restricts harness strap adjustment. It does not prevent buckle disengagement.
1
C. TONGUE BUCKLES (FIGURE 8C)
1. Engage: Insert the tongue through the buckle frame. Insert the buckle tab through one of the tongue grommets,
then insert the tongue through the strap keeper to secure.
2. Disengage: Remove the tongue from the strap keeper. Pull back on the tongue while also pulling back on the
buckle tab, until the two are released. Remove the tongue from the buckle frame.
3. Adjust: Secure the tab through different grommets to adjust fit. Move the tab inward to tighten, out to loosen.
1
D. PASS-THROUGH BUCKLES (FIGURE 8D)
1. Engage: Insert the male buckle through the slot in the female buckle. Tighten the harness strap so that the male
buckle is flush against the female buckle.
2. Disengage: Loosen the harness strap so that the male buckle separates from the female buckle. Once separated,
pull the male buckle out through the female buckle.
3. Adjust: Turn and hold the buckle 90 degrees from the harness strap. To shorten webbing, pull down on the
adjustment strap. To lengthen webbing, pull upwards on the buckle.
1
Figure 8A - Quick Connect Buckles
2
Figure 8B - Duo-Lok Quick Connect Buckles
2
Figure 8C - Tongue Buckles
2
Figure 8D - Pass-Through Buckles
2
18
3
3
3
3
Publicidad
