Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Wiring diagrams
CAUTION: THIS UNIT MUST HAVE AN EARTHING CONNECTION. ALL WIRING MUST BE COMPLIANT
WITH THE REGULATIONS IN FORCE IN THE COUNTRY OF INSTALLATION.
The unit is compatible for a single-phase 220-240 V, 50 Hz power supply .
The unit requires a flexible power cable. Connect the cable to the terminal block and let it out through a cable
gland and a cable clamp.
The unit must be connected directly to the power supply through a special magnetothermal switch.
CAUTION:
CAUTION:
7
Vmax start through light control
Through contact n.2 in figure 8, the machine can be connected to the switch of a room, which coming on it
starts the machine at maximum speed. The machine start-up and shutdown delay they can be adjusted using
the appropriate "ON DELAY" and "OFF DELAY" menus as described in the paragraph "Operation with
remote control display".
70
To connect the HMI remote display to the machine, use cables with a section between
0.35 mm
2
and 2.5 mm
should be kept separate or away from the power cables, if there are problems
of electromagnetic interference from other devices installed in the environment (which
produce malfunction of the display), it is recommended to use shielded cables.
To connect the product power supply, use a cable with a minimum section of
3X0.75 mm
2
H05VV-F.
2
. Max length 100 m. Given that the display connection cable
Mains cable
Publicidad
