ELBE ABT-503-NE Manual De Instrucciones página 16

B. Pairing the headset with Bluetooth mobile phone
Please make sure your mobile phone has Bluetooth function that can be used.
Notes: Specific pairing procedures may vary with different mobile phone. Please refer to
your mobile phone manual for further information. Steps as follows:
1. Please keep the headset and mobile phone in the range of 1 meter when pairing.
2. Make the headset enter into pairing mode (LED is red and blue blinking)
3. Start the Bluetooth function of mobile phone and search for new Bluetooth devices.
After searched, select "ABT-503-NE"in the Bluetooth device list.
4. According to indication, enter password or PIN No:"0000", and press the key of" Yes"
or "confirmed".
5. After successful pairing, select "ABT-503-NE" in the Bluetooth device list, and press
"connect".
6. After connect successfully, the blue LED of the headset will keep blinking.
Notes:
If the pairing is not successful, please switch off headset firstly, and then re-pair again.
•
After pairing is successful, paired devices will remember each other. Unless pairing
•
information is deleted because of new pairing, no need to pair when use next time. If
you want to pair the headset with other devices, please pair it with the new device
according to steps 1～6 mentioned above.
Multilink technology allows simultaneous connection to two different devices, just
•
simply repeat the pairing process on both devices.
Although WIN7 is a superior operating system with most drivers already built-in, in
•
some cases this does not cover the various hardware configurations built into the
device (e.g. PC, Note book, Net book etc) from the manufacturer. In this case, please
visit the manufacturer's web site for the latest Bluetooth drivers for your onboard
Bluetooth device.
( It depends on the Bluetooth device setting. )
16