Uline BUNN H-10275 Guia De Inicio Rapido página 2

1. When the flow of water from the funnel stops,
connect the brewer to the power source and wait
approximately 20 minutes for the water in the tank to
heat to the proper temperature.
Some water will drip from the funnel during this
time; this is due to expansion and should not
occur thereafter.
2. Empty the dispenser and replace it under the
funnel.
3. Open the flip lid on top of the brewer and pour in
one pitcher of tap water.
1. Insert a Bunn® filter into the funnel.
2. Pour the fresh coffee into the filter and level the bed
of grounds by gently shaking.
3. Slide the funnel into the funnel rails.
4. Place an empty dispenser beneath the funnel. Turn
on lower warmer switch. (See Figure 2)
5. Open the flip lid on top of the brewer and pour in
one pitcher of tap water. (See Figure 2)
6. When brewing is completed, discard the grounds
and filter.
1. The use of a damp cloth rinsed in any mild,
non-abrasive liquid detergent is recommended for
cleaning all surfaces on coffee maker.
2. Check and clean the sprayhead. The sprayhead
holes must always remain open. (See Figure 3)
3. With the sprayhead removed, insert the deliming
spring (provided) fully into the sprayhead tube.
When inserted properly, no more than two inches of
spring should be visible. Saw back and forth five or
six times. (See Figure 3)
NOTE: In hard water areas, this may need to be
done daily. It will help prevent liming problems
in the brewer.
PAGE 2 OF 6
INITIAL SETUP CONTINUED
4. When water has stopped flowing from the funnel,
5. Empty the dispenser. The brewer is now ready for use
COFFEE BREWING
CLEANING
1-800-295-5510
uline.com
let the water in the tank reheat to the proper
temperature.
in accordance with the coffee brewing instructions
below.
NOTE: The control thermostat will need to
be adjusted downward to compensate for
high altitudes. Refer to service manual for
instructions.
Figure 2
Lower Warmer
Switch
Dispenser
Figure 3
Sprayhead
Deliming
Spring
0724 IH-3562