Kesser K-GHG-2022 Manual De Instrucciones página 12

4. Right Side Housing Panel
5. Insulation Board
6. Protection Grid
7. Tank Cover Assembly
8. Ceramic Burner
9. Wheels
10. ODS assembly (Oxygen Depletion System)
11. Switch
12. Impulse Ignition
13. Gas valve
ASSEMBLY INSTRUCTIONS
Notes:
Before assembly, make sure all packing and transit protection material must be
⚫
removed.
After removing the heater from its packaging, check it for damage: if you are
⚫
unsure, do not use the appliance and contact qualified service personnel. The
packing materials should not be left within the reach of children because they
are potentially dangerous; dispose of them in conformity with the law.
ASSEMBLY (FIG.1-3)
3. Insert rear base (14) into slots of front base along arrow direction and push on rear
base to fix, then fix rear base into front base using 2pcs M8 screws (A)and washer
(B).
4. Attach the tank cover (7) to the slots in the housing side sections.
BATTERY REPLACMENT
Remove impulse ignition cap (12) by turning cap counterclockwise. Install 1 AAA
battery. Negative end of battery goes in first, then replace impulse ignition cap (12)
by turning cap clockwise.
GAS REQUIREMENTS & CHECKING FOR LEAKS
Small deviations may occur. This is not related to quality but subject to
⚫
improvements.
The appliance must only be powered with LPG gas less than 15-kg cylinder.
⚫
The regulator must be EN12864 approved and the hose must be EN1763-1
⚫
approved with a length less than 50 cm.
Connect one end of the hose to the pressure regulator and the other end of
⚫
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
12
www.eshopping.de