Kokido EV22 Manual De Usuario página 12

How to remove the battery pack (To be carried out
by authorized technician)
Recommended tools (not included): Screwdriver.
WARNING!
mains before removing the battery pack.
1) Place the pool vacuum on a flat surface. Use the screwdriver to pry
open the small cover and unfasten the screw on middle. Remove the
top cover from the cleaner.
2) Unscrew all screws and remove both front and back bracket.
3) Unscrew all screws and remove the top round cover. Remove the
PCBA from the unit and locate the battery cable connector. Press on
the clip of the connector to pull it out. NOTE: Wrap the connector
immediately with insulating tape in order to avoid any short circuit
caused by the contact of both wire terminals.
11
The pool vacuum must be disconnected from the supply
2
1